Heating & Geyser Services
Geyser and Heater Services Built Around Safe, Reliable Warmth.
From electric, gas and instant geyser repair to installation, gas to electric conversion and room heater faults, Al-Bari brings every heating job together under one careful standard.
Geysers and heaters
Inspect, explain, complete
Gas and ventilation checked
One heating pillar
A Clear Starting Point for Every Hot Water and Heating Need.
Geysers and room heaters fail in different ways, and the right fix depends on whether the unit runs on gas, electricity or both. This page brings our geyser, heater and gas safety work into one place, so you can find the right service before winter puts the most strain on your system.
Service availability may vary by city. We assign gas and heating work only when a technician with the right skills, tools and parts is available in your area.
Complete heating support
Explore Our Geyser and Heater Services.
Thirteen practical services, grouped so you can quickly find the right repair, installation or safety check.
01
Electric Geyser Repair
We repair electric geysers that stop heating, heat slowly or trip the breaker when switched on. The technician tests the heating element, thermostat, thermal cutout and wiring to find which part has actually failed. After the repair, we fill and run the geyser to confirm it heats properly and the supply stays stable.
02
Gas Geyser Repair
We diagnose gas geysers with a pilot that will not stay lit, a weak or yellow flame, or a burner that fails to ignite. Our technician checks the thermocouple, gas valve, burner and flue before recommending a repair. Once fixed, the geyser is relit and watched through a heating cycle to confirm a steady, clean flame.
03
Instant Geyser Repair
We repair gas and electric instant geysers that fail to ignite, cut out during use or deliver water that keeps turning cold. Common causes include weak ignition batteries, a faulty flow sensor, low water pressure and blocked burners or elements. The unit is tested at normal tap flow so you can confirm hot water arrives quickly and stays consistent.
04
Geyser Leakage Repair
We trace water leaking from the geyser tank, safety valve, drain valve or inlet and outlet connections. Loose fittings and worn valves are tightened, resealed or replaced, and we tell you honestly when a corroded tank cannot be repaired safely. The connections are then checked under normal water pressure to confirm the leak has stopped.
05
Geyser Temperature Control Repair
We fix geysers that overheat, produce scalding water or never reach the temperature set on the dial. The technician checks the thermostat, gas control valve and safety valve, since these parts decide how hot the water gets and when heating stops. Water temperature is checked at the tap after the repair so you know the control is working.
06
Geyser Installation
We install new and replacement electric, gas and instant geysers in a position that allows safe fixing, ventilation and service access. The technician checks the wall strength, water connections and the gas supply or electrical circuit before mounting the unit. After installation, the geyser is filled, checked for leaks and run until it heats correctly.
07
Geyser Dismounting & Shifting
We remove geysers during renovation or a house move, and refit them at the new location when the unit is in good condition. Water and gas or electrical supplies are isolated first, and the open points are capped safely. Once refitted, the geyser is checked for leaks, secure mounting and normal heating before handover.
08
Gas to Electric Geyser Conversion
We convert suitable gas geysers to run on electricity when the gas supply is unreliable or no longer available. The technician checks the tank condition and fitting points, installs a compatible heating element and thermostat, and connects it to a correctly rated circuit. The converted geyser is tested for heating, leaks and electrical safety before use.
09
Geyser Servicing & Descaling
We service geysers before winter by flushing sediment from the tank and removing scale from elements and burners where they can be reached. Hard water leaves deposits that slow heating and raise running costs, so cleaning helps restore normal performance. The visit ends with a safety valve check and a full heating test.
10
Gas Heater Repair
We repair gas room heaters that will not light, lose the flame, burn yellow or shut off soon after starting. The technician checks the igniter, thermocouple, control knob, burner and supply connection to find the actual fault. Repaired heaters are tested in a ventilated room to confirm a stable, clean flame.
11
Gas Heater Leakage Repair
We trace gas smells around heaters and geysers to the hose, regulator, valve or connection point at the appliance. Worn hoses and loose fittings are replaced or resealed, and every repaired joint is checked for leaks before the supply is reopened. Work on the gas company meter or main supply line is not part of this service.
12
Electric Heater Repair
We repair fan heaters, rod heaters and oil filled radiators that stop heating, trip the power or show burning at the plug or cable. The technician checks the element, thermostat, safety cutout, switch and wiring before recommending a repair. Oil filled radiators that leak oil are not safe to reseal, so we will recommend replacement instead.
13
Gas Safety & Ventilation Check
We inspect gas geysers and heaters for leaks, flue condition, room ventilation and safe placement before winter use. Poor ventilation can let carbon monoxide build up indoors, which is why this check matters most in bathrooms and closed rooms. You receive clear findings and any recommended corrections before further work goes ahead.
Can't Find Your Problem Here?
Describe the symptoms on WhatsApp or call us. We will match it to the right technician and confirm availability before anyone visits.
Know your system
Electric, Gas or Instant. Each One Fails Differently.
Knowing which type you have helps us send the right technician with the right parts, and helps you describe the problem clearly when you call.
Electric Geyser
How it heatsA heating element inside the tank warms the water, controlled by a thermostat.
Common faultsBurnt element, faulty thermostat, tripping breaker and scale buildup.
What we checkElement, thermostat, cutout, earthing and the supply wiring.
Gas Geyser
How it heatsA burner under the tank heats the water, lit by a pilot and controlled by a gas valve.
Common faultsPilot going out, weak or yellow flame, gas smell and a blocked flue.
What we checkThermocouple, gas valve, burner, flue and room ventilation.
Instant Geyser
How it heatsWater is heated only while it flows, so there is no storage tank.
Common faultsNo ignition, cutting out during use and cold water at low pressure.
What we checkIgnition, flow sensor, water pressure and the burner or element.
Not sure which type you have? Send a photo of the unit or its label and we will tell you.
Heat tested before handover
Every repair ends with a running check
Capability with boundaries
Safe Heating Work Starts With Knowing the Limits.
Gas and hot water equipment can cause real harm when it is handled carelessly. We explain what we can fix, what we cannot and when a unit is safer to replace, so you decide with the full picture.
What we handle
- Electric, gas and instant geysers in homes and small businesses
- Gas and electric room heaters
- Leaks at the appliance, its valves and connections
- Testing every repair before handover
What we do not take on
- Gas meter or main supply line work, which belongs to the gas company
- Resealing corroded tanks or leaking oil radiators
- Large commercial boilers and central heating plants
- Brand authorisation or warranty claims we do not hold
Three service groups
One Standard. Three Areas of Heating Support.
Each group needs different skills and safety checks, so we keep them separate and send the right technician to the job.
01
Geyser Repair
Electric, gas and instant geyser faults, leaks and temperature control problems.
5 services
02
Installation & Care
New installation, shifting, gas to electric conversion and seasonal servicing.
4 services
03
Heaters & Gas Safety
Gas and electric room heater repair, gas leakage at the appliance and ventilation checks.
4 services
Warning signs
When to Book a Check and When to Act Now.
Most heating faults give early signs. Some can wait for a planned visit, while others need you to switch off the supply first.
Book a check soon
These signs point to wear that gets worse and more costly with time.
- Water takes longer to heat than it used to
- Hot water looks rusty or muddy
- Rumbling or popping sounds from the tank
- The safety valve drips steadily
- The pilot goes out now and then
Switch off and call
Turn off the gas or power supply first if it is safe to reach, then contact us.
- A smell of gas near a geyser or heater
- Scorch marks or a burning smell at a switch or plug
- Water leaking near electrical connections
- A yellow flame with black soot marks
- The breaker trips every time the geyser runs
How we work
From First Call to Final Heating Check.
A simple process keeps the job clear from the first call to the final test.
01
Share the Problem
Tell us the appliance, whether it runs on gas or electricity, and what it is doing. A photo of the unit or its label helps us send the right technician.
02
Confirm the Visit
We check technician availability in your area and confirm a suitable time before anyone is assigned.
03
Inspect and Explain
The technician isolates the supply, finds the fault and explains the repair and cost before work begins.
04
Repair and Test
Approved work is completed, the supply is restored and the unit is run until it heats correctly.
Evidence-led service
Every Job Should Leave More Than Just a Verbal Promise.
Heating faults are easy to misjudge, so we record what was found, what was replaced and how the finished work was tested.
- Before and after photos
- Parts replaced record
- Leak and heating test
- Clear handover
Fault record
What was wrong and why.
Safety check
Gas joints or earthing checked.
Running test
Heat confirmed at the tap.
Handover notes
Safe use and care advice.
Seasonal care
A Simple Heating Calendar for Every Season.
Geysers and heaters work hardest for a few months each year, so timing your care avoids most breakdowns.
October to November
Before Winter
Service the geyser, flush sediment, test the safety valve and check that gas heaters burn with a clean blue flame.
December to January
Peak Winter
Watch for weak flames, low gas pressure and pilots that keep going out, and keep rooms ventilated while heaters run.
February to March
End of Winter
Note any faults that appeared during the cold months and book repairs before the unit sits unused.
April to September
Quiet Months
Switch off unused geysers safely and plan installation, conversion or replacement work before demand returns.
Expanding city by city
Need Geyser or Heater Service in Your City?
Share your city and the heating service you need. We will confirm current coverage, check technician availability and book the visit only when the right person can attend.
- City and service requirement reviewed
- Suitable technician assigned when available
Quick Checks Before You Book
What You Can Check Before Calling a Geyser Technician
Some heating problems have a simple cause you can check safely yourself. If these checks do not solve it, or you smell gas at any point, stop and book a visit.
01
Check the Gas Supply First
If a gas geyser or heater will not light, check whether the other gas appliances in the house are working. Low gas pressure in winter is a common reason for weak flames and pilots that keep going out. If the stove burns normally but the geyser still fails, the fault is likely in the geyser itself.
02
Replace the Instant Geyser Batteries
Many gas instant geysers use batteries to create the ignition spark. When the clicking becomes weak or stops, fresh batteries often solve the problem straight away. If ignition still fails with new batteries, the flow sensor or igniter needs inspection.
03
Look at the Breaker for an Electric Geyser
An electric geyser that suddenly goes cold may simply have tripped its breaker. Switch it back on once and let the geyser run. If it trips again, leave it off, because a failed element or wiring fault needs proper testing.
04
Flush a Little Water Before Winter
Sediment settles at the bottom of a geyser tank over the summer and slows heating. With the geyser switched off and cooled, run water from the drain valve until it comes out clear. If the water stays muddy or the valve will not close properly, book a full service.
05
Never Sleep With a Gas Heater On
A gas heater in a closed room uses up oxygen and can produce carbon monoxide, which has no smell. Keep a window or door slightly open while it runs and switch it off before sleeping. If the flame burns yellow or the room feels stuffy, have the heater checked.
06
If You Smell Gas, Act First
Close the gas valve at the appliance, and the main valve if you can reach it safely. Open windows and doors, and do not switch lights or appliances on or off. Leave the area and contact your gas company emergency line before booking a repair.
Helpful answers
Geyser and Heater Questions
Answers about repairs, conversion, safety and what to expect.
Still need help?
Speak directly with Al-Bari Services.
Should I repair my old geyser or replace it?
Repair usually makes sense when the fault is in a replaceable part such as the element, thermostat, thermocouple or valve. If the tank itself is corroded or leaking, replacement is the safer choice. The technician will explain which applies after inspecting the unit.
Can any gas geyser be converted to electric?
Not every model is suitable. Conversion depends on the tank condition, the available fitting points and whether your electrical supply can take the extra load. We check all three before recommending it.
Why does my geyser pilot keep going out?
Common causes include low gas pressure, a weak thermocouple, a dirty pilot assembly or a draught near the flame. The technician tests each one to find the actual cause rather than replacing parts by guesswork.
Is it safe to use a gas heater overnight?
No. A gas heater should not run in a closed room while people sleep, because carbon monoxide can build up without any smell. Switch it off before sleeping and keep the room ventilated while it is in use.
Do you repair electric instant geysers too?
Yes. We repair both gas and electric instant geysers, including ignition, flow sensor and element faults. Share the brand and model when booking so the technician can bring suitable parts.
How do I book a heating service?
Call 0301-977-1025 or send a WhatsApp message with the appliance type, whether it runs on gas or electricity, your area and the problem you noticed. We will confirm availability and a visit time.
Related services
Other Services From the Same Team.
Many heating jobs touch wiring or water lines. The same inspect, explain and test process applies across every service.
Electrical
Electrical Services
Wiring, panels, power backup and supported appliance repair. Useful when a geyser needs a new circuit or a correctly rated breaker.
Explore Electrical
Cooling
Cooling & AC Services
AC repair, installation, servicing and gas filling, handled with the same inspect and test approach before summer.
Explore Cooling
Plumbing
Plumbing Services
Leaks, water lines, tanks and fittings, including the supply connections that feed your geyser.
Explore Plumbing
Heating help starts here
No Hot Water or a Faulty Heater? We'll Confirm the Right Next Step.
Share the appliance type, the problem and your location. Our team will confirm availability, scope and the right technician.